Home elevator How to install, Home elevator Common assembly problems, villa installation Home elevator It has been very widespread for a long time, but many villa owners are hesitant when choosing Home elevator They are unsure how to install it and what precautions to take,

Check Home elevator Operation, adjustment and cleaning of door drive components. Clean the landing door, hall door sill and door slide rails. Check the gap between all door rollers and the open door blade. Adjust all hall doors and accessories. Clean all hall anti-theft lock switch contacts. Check if the compensation chain is intact. Check the damage condition of the elevator car and counterweight guides. Check the gap between the safety clamp and the guide rail. Check the tension of the traction rope. Check the operation of the elevator car control panel and each button. Check Home elevator The operation of the car emergency lighting. Check if the induction door can be reopened without issues.

Home elevator Cleaning and lubrication of guide shoes: We all know that guide shoes operate on guide rails, and there are oil marks on the guide shoes, so that the elevator does not produce friction noise during operation. Need It is necessary to regularly lubricate and clean the oil marks on the guide shoes, and the Home elevator Car environment hygiene. Elevator hall door and landing door lubrication: Lubricate the oiling area on the upper sill of the door to maintain stable lubrication, so the elevator will not make unpleasant noises during operation and door opening. Elevator overhaul: The concept of overhaul is to repair some parts of the elevator, basically without disassembling the complex parts of the elevator, which can ensure that the independent villa Home elevator Industrial equipment in normal operation.

The nuts of the reducer base should be tightened and free from any loosening problems. When the reducer is operating under normal conditions, the ambient temperature of its parts and bearings should generally not exceed 80℃. When Home elevator If the rolling bearings in the reducer cause high fever and the ambient temperature exceeds 80℃, or cause obvious uneven noise, or even grinding and knocking sounds, the rolling bearings should be replaced. When checking the teeth of the reducer gears and racks and the condition of the rolling bearings, Need When disassembling the reducer, first Home elevator Place the car at the top of the elevator shaft, use a hoist to hold it, and use wooden blocks to support it at the bottom pit. Then drain the grease from the reducer and clean it with gasoline.

When measuring the span, a plumb line is essential. When measuring the lifting height, make sure it is the finished decorative surface. On the steps /There must be an unobstructed distance of at least 2.3 meters in the foot pedals. If one Home elevator The lifting height of another elevator in 3.3 meters, it is impossible to achieve a 2.3-meter top clearance. The vertical distance above the handrail area must exceed 2.1m. The bottom pit may be bottomless, but the steel bar lap joint Need Is concrete.